Installation Tips
No pegs required! Just hammer in place!
- Conveniently bend to required shape
- Rolled edge for extra safety
- Easily bend teeth out of the way of roots, pipes or rocks
Installation Steps
Before you begin
Check for roots, pipes, rocks or cables that might be in the way.
Step 1
Remove joiner components and plastic film.
Note: You may want to use your pliers.
Step 2
Place edging in desired location.
Step 3
Using a block of wood and a hammer, knock edging into place.
Step 4
Bend joiner (A) with pliers and push prongs through holes in edging and joiner (B). Bend prongs to lock in place. Ensure to use your pliers for a firm assembly.
Included in this pack
Tools required (not supplied)
Tree rings
500 x 500mm square
Follow the installation steps in conjunction.
– Use 2 x full length pieces.
– Bend each length twice:
– Piece (A) – from the left side bend after 2nd tooth (200mm) and from the right side after 3rd (300mm) tooth.
– Piece (B) – from the left side bend after 3rd tooth and from the right side after 2nd tooth.
– Use the joiners to secure the assembly.
400 x 400mm square
(method 1)
Follow the installation steps in conjunction.
– Use 2 x full length pieces.
– Bend each length three times:
– Piece (A) & (B) – bend in half and then from each end bend after the 1st tooth (100mm).
– Form a square. There will be an overlap of 200mm.
To secure assembly: using the existing hole as a guide, drill through other piece and pop-rivet (not supplied) together.
400 x 400mm square
(method 2)
Follow the installation steps in conjunction.
– Use 2 x full length pieces.
– Cut back one piece to 6th tooth (600mm).
– Bend each length twice:
– Piece (A) – full length – from each end bend after the 3rd tooth (300mm).
– Piece (B) – 600mm length – from each end bend after the 1st tooth (100mm).
– Drill a 6mm hole at the cut end of Piece (B). Ensure it is of equal height and distance as the other end.
– Use the joiners to secure the assembly.
625mm dia. circular
Follow the installation steps in conjunction.
– Use 2x full length pieces.
– Lightly bend after each tooth (100mm) to form both pieces into a semicircle.
– Use the joiners to secure the assembly. – You may need to adjust the shape slightly to achieve a full circular shape.